Ctek Automation Control Application APN007 Manuel d'utilisateur télécharger pdf (Page 15)

Application Note – Automation Control Application

APN007 25 July, 2014

Note:

The default commend described above uses a broadcast that will set the address of all physical

modules to 99. You may want to disconnect modules from the line up that do not require their

address to be resored to default.

Disable

Disabling a module removes it from the communications routine. All set up information for the

disabled module remains intact. Disable can be a useful troubleshooting tool when diagnosing

communications problems or configuration issues.To disable a module enter its module number

and press submit.

Figure 9 - Disable I/O Module

Enable

Enabling a module returns a disabled module to service. Setting previously stored on the module

will be used. To enable a module enter its module number and press submit.

Figure 10 - Enable Module

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Pas de commentaire

Ctek Automation Control Application APN007 Manuel d'utilisateur Page 15